Wet and sloppy snow today so I spend some time on Joe projects. The Joe tank project made some progress today. The challenge was the driver and gunner area of the tank. First I cut two holes in the head wall so that I could make more room for the driver and gunner, and also have a hole I could pass the radio through.
I'll mount the radio underneath on the rear headwall.
Then I made a form-fit plastic cover. This plastic cover fit over the electric motors and front electronics.
Then I made two seat backs - they fit into the holes I had cut earlier. These hold the driver and gunner quite nicely.
..
??????
I'll mount the radio underneath on the rear headwall.
Then I made a form-fit plastic cover. This plastic cover fit over the electric motors and front electronics.
Then I made two seat backs - they fit into the holes I had cut earlier. These hold the driver and gunner quite nicely.
..
??????
Comment